Most Recent Pins (33)
Conner Droke
Solace Heating and Air cleaned the vent motor pressure area to remove wasp blockage caused by cold outdoor temperatures. After cleaning, they tested the unit to ensure proper operation and found no issues. This service was performed in the local area.

Conner Droke
Solace Heating and Air diagnosed a faulty vent motor causing loud noise and pressure issues. After replacing the motor, the unit operated properly without any problems. This heating and air service ensures vent motors function correctly to maintain system performance. Location details are not specified.




Jared Coel
Solace Heating and Air replaced an inducer motor relay on a Goodman gas package unit in Jackson, TN, ensuring reliable heating during winter by verifying system operation post-service.





Jared Coel
A technician in Jackson, Tennessee inspected a Goodman gas package system that was not producing heat. They identified a dirty flame sensor as the problem, cleaned the sensor, and confirmed that the system was heating correctly.






Jared Coel
A technician inspected an Airease gas furnace in McKenzie, Tennessee that was not producing heat. The issue was traced to a locked gas meter, and the cause was explained to the customer.





Jared Coel
Solace Heating and Air replaced a failed inducer motor, gas valve, and control board on a Goodman gas furnace in Jackson, Tennessee, verifying proper operation to ensure reliable heating during winter months.





Jared Coel
A technician in Linden, Tennessee inspected a York high-efficiency condensing furnace due to a strong odor. The source was traced to the condensate drain. To resolve the issue, the technician installed a drain trap to separate the furnace from the drain line.





Jared Coel
Solace Heating and Air completed a combustion analysis on a propane gas package unit in Jackson, Tennessee. The technician confirmed the unit operates efficiently and burns cleanly, ensuring proper fuel use and system performance.





Jared Coel
Solace Heating and Air inspected an Ameristar gas package system in Brownsville, Tennessee. Technicians found the unit operational but detected a weak blower motor capacitor. They replaced the capacitor to maintain proper heating function.





Jared Coel
Solace Heating and Air repaired a 20-year-old American Standard gas furnace in Brownsville, Tennessee. The technician replaced a faulty inducer motor and a weak blower capacitor. The system was tested and confirmed to be heating properly after the repair.





Jared Coel
Solace Heating and Air serviced gas logs in Jackson, Tennessee. The team cleaned the thermocouple, repaired a damaged thermostat wire, and confirmed proper thermocouple voltage to prepare for upcoming cold weather.


Jared Coel
A technician in Jackson, Tennessee inspected a Nordyne gas furnace that was not producing heat. They identified a weak blower capacitor and a low-reading flame sensor. The technician explained the issues and presented the customer with repair options.





Jared Coel
A technician in Jackson, Tennessee inspected two gas package HVAC systems with separate issues. The inspection included heat exchangers, blower motors, coil condition, and electronics. The technician completed a detailed assessment of both systems to determine their operational status.





Kein Hernandez
Solace Heating and Air replaced a blower motor and blower motor control board in Jackson, Tennessee. Technicians completed the repair and confirmed the equipment is working correctly. This service restored full function to the HVAC system.




Conner Droke
Solace Heating and Air cleaned a dirty flame sensor on a heating unit in Dallas, Texas. The technician inspected the system and confirmed all functions operated efficiently after service.




Jared Coel
Solace Heating and Air replaced a faulty high limit switch on a two-month-old Ameristar unit in Sacramento, California. The part was under warranty and the repair restored proper system function.

Conner Droke
Solace Heating and Air replaced a gas valve on a new American Standard unit in Philadelphia, Pennsylvania. They reset the pressure to 3.3 and verified that the heating system operated correctly after testing. The system showed no further issues at the time of service.

Conner Droke
A technician inspected a new gas floor heater in Lake Havasu City, Arizona, but could not complete testing because the connected propane tank was empty. Service will resume once the propane supply is restored.

Jared Coel
Solace Heating and Air installed a new floor furnace in Fresno, California. Technicians added new venting and thermostat wires. They tested the system and confirmed the furnace functions correctly.

Jared Coel
Solace Heating and Air repaired a Rheem gas furnace in Greenville, South Carolina. A damaged pressure tube caused heating failure. Technicians identified rodent damage to the tubing between the inducer motor and pressure switch. They replaced the tubing and restored full operation of the furnace.

Kein Hernandez
Solace Heating and Air replaced a failing blower motor on a 2014 Trane gas package system that had no heat. This heating repair service was completed in Jackson, Tennessee.


Kein Hernandez
Solace Heating and Air completed a fall maintenance check on a 2024 American Standard gas package system in Jackson, Tennessee. The technician confirmed that all components of the system are operating correctly. This service helps maintain energy efficiency and consistent performance through seasonal changes.






Kein Hernandez
Solace Heating and Air replaced a recalled control board under warranty in Jackson, Tennessee. The replacement included both parts and labor at no additional cost. The service ensured the HVAC system continued to operate reliably and safely.




Jared Coel
A technician diagnosed a no-heat issue on a Trane gas furnace and identified a faulty hot surface igniter. The team replaced the igniter and confirmed the furnace is now heating correctly. This service was completed by Solace Heating and Air. Location data was not provided for this job.

Jared Coel
Solace Heating and Air repaired a non-working Trane package system in an older unit in [City, State unavailable]. The technician identified a faulty inducer motor and a rusted burner assembly, then explained available repair options to restore heat and system function.

Jared Coel
Solace Heating and Air completed fall heating maintenance on an Ameristar gas package system. The technician inspected the burners, inducer motor, igniter, and heat exchanger to ensure they were functioning properly. This service helps maintain system efficiency and supports reliable heating performance through the colder months. Location details were not provided.

Jared Coel
Solace Heating and Air completed fall heating maintenance on a Trane gas package system in [City], [State]. The technician inspected the unit, found corrosion on the burner assembly, discussed repair options, and confirmed the system works properly for winter use.




Jared Coel
A technician inspected a Rheem gas package unit and found a rusted inducer motor causing a no-heat issue. The technician explained the problem and discussed repair options with the customer in Fort Smith, Arkansas.




Jared Coel
Solace Heating and Air completed fall maintenance on a Bryant gas package system in North Carolina. Technicians cleaned rusted burners that were preventing ignition. They inspected the heat exchanger, inducer motor, and related components to confirm proper function before winter.




Jared Coel
Solace Heating and Air completed fall maintenance on a Trane gas package system in North Carolina. Technicians removed a wasp nest from the inducer motor, inspected all heating components, and confirmed the unit operates correctly. The system is now ready for the colder season and functioning as expected.




Jared Coel
Solace Heating and Air replaced a recalled control board on an American Standard gas package unit in Denton, Texas. The team confirmed the unit now operates correctly with no remaining issues.




Jared Coel
A technician in Jackson, Tennessee replaced a damaged blower motor and furnace control board on a York gas furnace. The repair restored full heating system function and ensured proper airflow and safety. System performance was tested and confirmed after installation.





Drew Layton

Maps data from OpenStreetMap © OpenStreetMap

